Fyne Audio FA302iC

Fyne Audio

Fyne Audio FA302iC
  • Fyne Audio FA302iC
  • FA302ic-Grille-off-3Q-large
  • FA302ic-3Q-Rear-large
  • FA302ic-Grille-On-Round-large
Varenr.
980009659
Pris
kr 1 795
Enhet
stk
Fri frakt over kr. 1000,-
Rask levering
Kvalitetsprodukter
Personlig service

Kvantumsrabatt

Loading...

Fyne Audio FA302iC er bygget på samme lest som lillebroren FA301iC, men har et kraftig 8" stort konsentrisk element for høy krafthåndtering og dypere bass. Som lillebroren gir den virkelig fantastisk valuta for pengene!

 

Informasjon fra produsent:

 

Stepping up to the potent 200mm (8”) multi-fibre bass / midrange driver and 25mm soft dome polyester tweeter, the FA302iC is a home installation powerhouse. High power handling, bass down to below 40Hz and adjustable tweeter pod to direct the sound give this model audiophile quality performance.

 

Derived from Fyne’s larger F300 series models, the FA302iC feature the FyneFlute roll surround for improved bass detail and a high specification crossover tuned to get the very best from in-ceiling or in-wall position.

 

Easy to fit clamps, spring cable terminals and a cut-out template make for easy DIY install, and the round low profile magnetic grille (square grille available as optional extra) sits almost flush to the surface.

 

The grille can be painted, enabling you to blend in or contrast with a wide variety of décor and room colours.

 

Specification:

 

System Type 2 way co-axial loudspeaker for in ceiling or in wall application, steerable HF unit
Recommended amplifier power (Watt RMS) 25 - 120
Continuous power handling (Watt RMS) 60
Peak power handling (Watt) 240
Sensitivity (2.83 Volt @ 1m) 90dB
Nominal impedance 8 Ohm
Frequency response (-6dB typical in room) 37Hz - 28kHz
Drive unit complement 1 x 200mm multi-fibre bass / midrange cone, FyneFlute surround with 25mm Co-axial polyester dome tweeter
Crossover frequency 2.8kHz
Crossover type Passive 2nd order low pass, 1st order high pass
Dimensions - Dia x Depth 273 x 115mm (10.7 x 4.5”)
Round grille diameter 281mm (11.1”)
Square grille dimensions 281 x 281mm (11.1 x 11.1”)
Cut-out diameter 248mm (9.8”)
Depth behind mounting surface 112.5mm (4.4”)
Clamp travel 5 - 50mm (0.2 - 2.0”)

 

    Din nettleser er utdatert!

    For å kunne bruke alle funksjoner på nettsiden må du oppdatere nettleseren. Oppdater min nettleser nå

    ×