Elac Miracord 50

Elac Miracord 50
Pris
kr 4 871,00
Før
kr 6 495,00
Enhet
stk

Kvantumsrabatt

Loading...
  • Elac Miracord 50
  • Elac-Miracord-50-1
  • Elac-Miracord-50-2
  • Elac-Miracord-50-4
Elac Miracord 50 er en flott og vellydende beltedrevet platespiller med innebygget RIAA-trinn som gjør at du kan koble den direkte til forsterkeren eller et sett aktive høyttalere.

Platespilleren er flott bygget og har avtagbart headshell med ferdig påmontert Audio Technica AT91 pick-up.

 

Spesifikasjoner:

 

Turntable Section

  • Drive System: Belt drive
  • Motor: DC motor
  • Selectable Speeds: 33? and 45 rpm
  • Motor Servo: Speed rotation and servo system
  • Rotation Speed Variation: +/-1%
  • Wow and Flutter: 1%
  • Signal-to-Noise Ratio: -67 dB or higher (A-weighted) -60 dB or higher (unweighted)
  • Platter: Aluminum die-cast
  • Platter Diameter: 0 in / 300 mm

Tonearm Section

  • Type: Aluminum tube, static-balanced
  • Effective Arm Length: 8 in / 223.6 mm
  • Stylus Pressure Range: 0 to 0 g
  • Cartridge Weight Range: 5 to 6.0 g
  • Effective Arm Mass: 4 g
  • Overhang: 6 mm
  • Offset Angle: 25 degrees
  • Anti-Skating: Adjustment Supported
  • Main Bearing: Stainless steel

Cartridge Section:

  • Type: Audio-Technica AT91 moving magnet
  • Stylus Construction: Bonded diamond
  • Mount: Half-inch
  • Frequency Response: 20 Hz to 20 kHz
  • Channel Separation: >18 dB
  • Channel Balance: 5 dB
  • Vertical Tracking: Angle 20 degrees
  • Stylus Pressure: 0 g +/-0.5 g
  • Cartridge Weight: 0 g +/-0.5 g
  • Headshell Weight: 0 g (including screws, nuts and wires)

Phono Equalizer Amplifier

  • Type :Moving magnet (MM)
  • Phono Output: 5 mV (1 kHz, 3.54 cm/sec)
  • Line Output: 140 mV (-17 dBV)
  • Phono/Line: Switchable
  • Supported Load Impedance: 47 kO
  • Connector: RCA pin jack including RCA cable accessories
  • Voltage: 100 to 240 V AC / 50 to 60 Hz
  • Power Consumption: 1.5 W (less than 0.5 W at standby)
  • Dimensions: (WXHXD) 5.5 x 16.05 x 14.20
  • Weight: 12.10 lb